Alpha Microsystems AM-648 Installationsanleitung PDF herunterladen (Seite 10)

Page 7Installation Instructions: AM-3501 Expansion Subsystem

To install a peripheral device, simply slide it into one of the available mounting positions

in your subsystem chassis and install the four screws (two on each side) that hold the

device in place.

In order to install peripheral devices in mounting positions 3, 4, 5, and 6, you will need to

remove the side mounting plate as shown in the following illustration.

POWER SUPPLY

MC1158

MAIN ELECTRONICS BOARD

MOUNTING BRACKET

To remove the board mounting

assembly, you must remove

these two screws.

Side Mounting Plate Removal

5.1Internal SCSI Bus and Power Cables

There is a SCSI interface cable with four 50-pin connectors already installed in your

chassis. Simply plug the 50-pin connector into the back of the SCSI device, or devices

if you are installing more than one. Make sure the colored stripe on the cable aligns with

pin-1 on the device connector.

The subsystem power supply has four standard 4-pin DC power cables. Plug one of the

"keyed" DC power connectors into each device. Note that some cables have both a

standard DC connector and a minature (floppy drive type) connector attached for

convenience.

PDI-03501-00, Rev. A00

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Keine Kommentare

Alpha Microsystems AM-648 Installationsanleitung Seite 10